SINGLE-COMPONENT COATING
WALLS AND FLOORS
INDOOR AND OUTDOOR ENVIRONMENTS
Ready-to-use single-component coating
Can be applied directly to walls
and tiled floors
and with self-levelling
For Interior and Exterior use.
APPLICATION CYCLE
WALLS AND FLOORS WITH CEMENT-BASED SELF-LEVELLING COMPOUNDS
Apply one coat of PRIMER MONOLITH ATTAK
Necessary for surfaces with cement-based self-levelling agents.
- Apply one coat of PRIMER MONOLITH ATTAK.
Necessary for surfaces with cement-based self-levelling agents.
- Apply two coats of MONOLITH large grain
after 4-6 hours.
It isimportant to apply the first coat of Monolith neutral to ensure a better grip on the surface.
- Between the first and the second coat, drown the fibre mesh (140/150).
In case of critical surfaces and deep joints a third coat of Monolith should be applied.
When the product has dried (4-6 hours), sand the surface before applying the finishing coat. We recommend
(60/80).
- Then proceed with the application of MONOLITH medium grain to obtain a compact finish.
- If you wish to obtain a smoother effect, you can apply a
coat of fine-grained MONOLITH.
- Afterdrying (24-48h) depending on theweather conditions
youcan apply Microglass
Bi
Matt, Glossy or Semi-glossy depending on the desired effect.
(We recommend 2-3 coats)
Then proceed with the application of MONOLITH medium grain
to obtain a compact finish.
If you wish to obtain a smoother effect, you can apply a coat
of MONOLITH fine grain.
After 24 hours, Microglass Bi-Glass can be applied.
Opaque, Glossy or Semi-Glossy can be applied, depending on the desired effect.
(We recommend 2-3 coats)
WALLS AND FLOORS WITH BRICKS, MARBLE, CERAMICS, TILES.
- Apply two coats of MONOLITH large-grain
4-6 hours apart.
It is important to apply the first coat of Monolith neutral to ensure a better grip on the surface.
to ensure a better grip on the surface.
- Between the first and the second coat, drown the fibre mesh
(140/150).
- For all types of joints thicker than 2 mm it is
necessary to apply:
MONOLITHextra large grain in place of MONOLITH large grain following the same procedure,
then drown the fibre mesh between the first and second
coat.
When the product has dried (4-6 hours), sand the surface before applying the top coat.
before applying the top coat. Standard grit (60/80) is recommended.
- Then proceed with the application of MONOLITH grit
medium to obtain a compact finish. - If a smoother effect is desired, a coat of MONOLITH fine grain can be applied.
- Afterdrying (24-48h), depending on the conditions
climate, Microvetro Bi
can be appliedmatt, glossy or semi-glossy depending on the desired effect.
(We recommend 2-3 coats)